Maintenance
Changing the Headlight Bulb
You will need to order replacement bulbs from: www.infinityvac.com or contact Customer Service at:
1-888-668-9600.
Turn power off.
Unplug the vacuum.
Unlock vacuum and lay flat.
Insert a Flathead screwdriver into one of the two top slots of the Headlight Cover; gently pry off cover from slots.
Pull out the used light bulb.
Push new light bulb into place.
Slide bottom tabs of the cover in first; then snap top slots into place.
Resetting the Motor Thermostat
Your Infinity Upright Vacuum is equipped with a protective Motor Thermostat. If the motor should overheat, the thermostat shuts off the power.
To reset the Motor Thermostat:
Press the On/Off Button once to turn power off.
Unplug the vacuum.
Check for clogged hose or filter; unclog hose and replace filter. Refer to Checking for Blockages on page13.
Wait 45 minutes for vacuum to cool; then plug in the vacuum.
Press the On/Off Button to start the vacuum.
Note: if vacuum still does not start, contact Customer Service at:
1-888-668-9600.
Replacing the Power Nozzle Motor Belt
If the brush roll does not engage when the
To remove worn or damaged Belt:
IMPORTANT: Depress carpets side of pedal [back] to engage the brush roll for proper belt alignment.
If pedal is in the bare floors/tools position the belt will not align properly on the belt shifter and will break.
carpets
2 
Turn power off.
Unplug the vacuum.
Remove Dust Cup Assembly.
Lock vacuum, lay flat and turn over.
Use Flathead screw driver [or a coin] to turn three screws on the belt and brush roll cover counter clockwise (a) to unlock.
Remove Belt and Brush Roll Cover (b).
a 
b
Grasp both sides of the Brush Roll; with even tension, partially remove the right side from the side holder first then the left (c).
Then lift up the Brush Roll to relieve tension on the belt.
c
Slip Belt off the Brush Roll.
Remove Belt from the
d
With the Brush Roll free, inspect for any hair
14 | TOLL FREE: |
