![](/images/new-backgrounds/1018281/182819x1.webp)
6.Feed the speaker cable through the
7.If you want to hide the speaker cables in the wall you can use the cable entry hole in the underside of the base.
3.Connect the cable to the speaker terminals. Observe correct polarity. Speaker cable is usually
4.Insert the pivot into one or other of the two pivot holes in the speaker, depending on whether you wish to use the speaker vertically or horizontally.
5.Fit the blanking plug into the unused pivot location hole and then
8.Put the pivot back into place.
Attach the foot to the speaker
1.Remove the two screws and take off the rear cover plate from the the speaker. Use the hex key supplied to loosen the screws.
Adjust the angle of your speaker
1.You can tilt your speaker up or down on its foot and you can also rotate it. If you experience difficulty tilting or rotating your speaker, try loosening the fixing screws for the pivot cover plate on the foot.
2.Once you have adjusted your speaker the way you want it, fully tighten the fixing screws of the pivot cover plate on the foot. This will hold your chosen adjustment
ASSEMBLING THE FLOORSTAND
Assembling the stand
1. The Oreus stand is supplied with the base detached from the column.
2. The foot can be attached to the speaker at two different positions. The first position allows the speaker to be used vertically (normal for satellites), while the second allows it to be used horizontally (normal for the center channel). Note the blanking plug which fills the unused pivot hole on the rear of the speaker.
UK 5