Infinity Installation, Connecting The Remote Level Control To Basslink T, Under-Dashmounting

INSTALLATION

CONNECTING THE REMOTE LEVEL CONTROL TO BASSLINK T

The Remote Level Control may be mounted under the dash or may be dismantled and mounted in the dash for a factory appearance.

UNDER-DASH MOUNTING

Select a mounting location that allows easy access to the control while driving. Using the Remote Level Control as a template, mark and drill holes in the mounting surface. Attach the Remote Level Control using the mounting screws provided (Figure 10).

Figure 10. Under-dash mounting of the Remote Level Control.

IN-DASH MOUNTING

Disassemble the Remote Level Control by removing the two Phillips-head screws on the front panel, rear panel and on top. Remove the Remote Level Control’s bottom and side panels. Slide the Remote Level Control’s PC board forward to release the RJ11 connector from the back panel and remove the board along with the potentiometer, knob and connector as a single assembly.

Choose a mounting location that allows easy access to the control, and provides 1-3/4" clearance behind the mounting surface. Drill a 9/32" hole in the mounting surface. Feed the Remote Level Control’s potentiometer (with the knob removed) through the hole and use the nut provided to hold the control in place (Figure 11).

Figure 11. In-dash mounting of the Remote Level Control.

Route the cable behind the dash or other interior panels and under the carpet. Do not route the cable outside the vehicle. Connect the RJ11 cable between the RJ11 receptacle on the BassLinkT and the receptacle on the Remote Level Control (Figure 12).

Figure 12. Remote Level Control electrical connection.

POWER	LINE LEVEL	HIGH LEVEL
	INPUT		INPUT
		+	+
		L	R
		–	–

REMOTE LR

FUSE	+BATT REM GND	LEVEL
		CONTROL
25A

BassLink T

(Control Panel)

6