Tilting the Speaker
If needed, the enclosed stand allows you to tilt the speaker across a wide range (i.e., up a maximum of 18˚ or down a maximum of 7˚), as shown in Figure 3.
Important!
Do not exceed the tilt range. Doing so may cause the speaker to fall out of its stand.
Figure 3.
The customer is responsible for proper selection and use of mounting hardware, and for correctly and safely
Step One
Remove the wall bracket cover by removing the four wall bracket screws on the ends as shown.
Step Two
Run the speaker wire behind the wall bracket and out the hole in the center. After deciding where to place the center speaker, attach the wall bracket (in a horizontal position) to the wall using the appropriate screws and anchors.
Center Hole
Wall Bracket
Mounting Screws and Anchors
Not Included
Step Three
Run the speaker wires out through the hole in the center of the wall bracket cover. Resecure in place with the four wall bracket screws, as shown.
