Infinity Softworks manual Prelude Mts-Stand, Fasten the four

STEP 8

STEP 7

STEP 5

– Remove one foam pad,pull out the plastic bag and open it.Place it back into the opening of the base, taking care to fold it over the sides so as to keep sand from falling into the base. Fill the plastic bag with sand.

STEP 6 – Seal the plastic bag,making sure to tuck it back inside the base and place the previously removed foam pad on top of the sealed bag.Replace the foot with the same 1/4-20 Phillips screws.

– Turn stand over and slowly lower the tower assembly onto the stand,being careful to insert the alignment pins into their receptacle guide holes.

– Fasten the four

10-32 Socket Head Screws through the tower base as shown;two through the front baffle and two in the rear slot. Press flush into place two screw caps to hide holes in front-baffle base. Make sure that the alignment slots point toward the center to ensure that the surface curve matches that of the baffle.

PRELUDE MTS-STAND 3