English
PRECAUTIONS ON USING DEMOLITION HAMMER
1.Wear earplugs to protect your ears during operation.
2.Do not touch the tool during or immediately after operation. The tool becomes very hot during operation and could cause serious burns.
3.Before starting demolishing work or chiseling onto a wall or floor, thoroughly confirm that such items as electric cables or conduits are not buried inside.
SPECIFICATIONS
Voltage (by areas)* | (110V, 230V, 240V) |
Power Input | 1300W* |
1600/min. | |
Weight (without cord, side handle) | 11.0 kg |
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES |
| |
(1) | Case | 1 |
(2) | Bull Point | 1 |
(3) | Side Handle | 1 |
(4) | Hexagon Bar Wrench (for 8mm screw) | 1 |
(5) | Dust cover | 1 |
Standard accessories are subject to change without | ||
notice. |
| |
APPLICATIONS
Demolishing concrete, chiseling concrete, grooving, bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply and drainage work, interior jobs, harbor facilities and other civil engineering work.
OPTIONAL ACCESSORIES (sold separately)
◯Demolitioning
(1)Bull Point
Overall Length: 300, 380, 450 mm
◯Asphalt Cutting
(1)Cutter
Overall Length: 400 mm Width: 50, 75 mm
◯Groove digging and edging
(1)Cold chisel
Overall Length: 300, 380, 450 mm
◯Hammer Grease A 500g (in a can)
70g (in a tube)
30g (in a tube)
Optional accessories are subject to change without notice.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident.
3.Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
4.How to install dust cover (Fig. 1)
Allways install the dust cover on the tool.
Insert the dust cover until it lies flush in the groove.
5.Installing Tools
CAUTION
To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle.
NOTE:
When using tools such as bull points, cutters, etc., make sure to use the genuine parts designated by our company.
(1)Clean, then smear the tool shank with the grease provided.
(2)Slide the stop lever in the direction of arrow A and rotate it 180°.
Turn the notch of the tool shank downward and insert it fully into the hexagonal hole of the front cover. (Fig. 1)
4
