36
Replacing the lens
This projector is shipped without a lens. You can order a lens from
www.infocus.com (in select areas), your retailer or your dealer.
1Turn the projector off and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly.
3If a lens is not attached, remove the dust cap from the projector and go to Step
6.
4If a lens is attached, press and hold the release button located near the lens
(marked “Press: Release lens”) to release the lock.
5Twist the lens counter-clockwise and carefully remove it from the front of the
projector. Release the release button.
6Insert the new lens into the projector carefully, arrow side up, through the
front of the projector. Turn the lens clockwise until you hear a click.
7Plug in the power cord, turn on the power switch and press the Power button
to turn the projector back on. Note: Connection to a circuit with a minimum of
20A capacity is recommended.
8Activate the Center Lens feature in the Alignment menu. (This will allow the
lens to work properly.)
§(3)
(4)
(5)
(6)
Turn of f a nd
unplug projector
Wait 60
minutes
(1) (2)