InFocus SP-CEIL-001 installation instructions Description/Hardware, Step

Step 5

Install the two (2) conical spacers (K) and two (2) flat washers (J) two

(2)hinge pin screws (I) loosely on both sides of the base box (L). Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box. Install the two (2) angle locking screws (H) adjust the angle, lock it, and then tighten the hinge pin screws (I).

See Figure 3

Check all hardware for proper tighten and security.

The ceiling should be capable of supporting a weight of at least five (5) times the weight of 19 Lbs. If it cannot, the ceiling must be reinforced. Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury.

DESCRIPTION/HARDWARE

A. 4 (mm) x 20 (mm) Phillip screws (2ea)

B. 4 (mm) Quick release sleeves (2ea)

C. Projector (Not Supplied)

D. 4 (mm) x 16 (mm) Knurl knob (1ea)

E.SP-CEIL-001

F.Suitable Hardware (Commercially Available)

G.Ceiling Structure (See Warning Label)

H.6 (mm) x 12 (mm) Angle locking screw (2ea)

I.6 (mm) x 12 (mm) Hinge pin screw (2ea)

J.Flat washers (2ea)

K.Conical spacer (2ea)

L.PBB-10RL Base box/Jam screw (1ea)

M.Suspension Adapter Adjustable Pins (2ea)

N.SP-CEIL-EXT Adjustable suspesion Adapter (Optional)

For further information or ordering assistance contact us at the phone/address number shown on the front of this page.

27700B S.W. Parkway Ave.

Wilsonville, Oregon 97070-9215

Phone 1-800-294-6400 Fax

www.infocus.com