Ingersoll-Rand 651418-70-B, 651418-100-B Typical System View, PARTS LIST / 651418-XX-B, 2 7 10

TYPICAL SYSTEM VIEW

1.Install the material filter either at the inlet of material handling section or upstream from the other accessories (control handle, etc.).

2.Refer to typical installation (figure 2).

3.The filter unit was tested at the factory with a maximum work- ing pressure of 6,000 p.s.i. (414 bar).

4.One Y17-15-C pipe plug is included with this unit to plug the inlet port not being used. Two Y17-12-C pipe plugs are includ- ed with this unit to plug the outlet ports not being used.

cThese system components are shown for installation purposes only and must be purchased separately.

Main air supply

￿ 4-1/4" Pump
	F-R-L ￿
Filter
￿ Material	Mounting
Outlet Hose	Bracket ￿
	Material
	Inlet
	Hose ￿

			Figure 2
	PARTS LIST / 651418-XX-B
Item	Description (size)	(Qty)	Part No.	[Mtl]
1	Cap	(1)	92990-1	[C]
2	Gasket	(2)	91447	[D]
3	Spring	(1)	90408	[SS]
4	Guide Button	(1)	93949	[SS]
5	Ball (13/16” o.d.)	(1)	Y16-126	[SH]
6	Cartridge (see table, page 1)	(1)	93945-XXX	[SS]
7	Body	(1)	92412-1	[C]
8	Filter Body	(1)	92993	[C]
9	Pipe Plug (3/8 - 18 N.P.T.)	(2)	Y17-12-C	[C]
10	Pipe Plug (1 - 11-1/2 N.P.T.)	(1)	Y17-15-C	[C]

MATERIAL CODE

[C]= Carbon Steel

[D]= Acetal

[SH] = Hard Stainless Steel

[SS] = Stainless Steel

1 ￿

2

3 4 5

6

8

￿

2

7 9

10

2Apply Loctite® 277™ to threads.

3Tighten to 30 - 40 ft lbs (40.7 - 54.2 Nm).

Figure 3

y ARO® is a registered trademark of Ingersoll-Rand Company y

y Loctite® is a registered trademark of Henkel Loctite Corporation y y 277™ is a trademark of Henkel Loctite Corporation y

PN 97999-8

Page 2 of 2 651418-XX-B (en)