Ingersoll-Rand 5212-15, 7015-11, 5213-1B manual Short Grinder, M10, Released, 2884-2

OPERATOR’S		MANUAL	SECTION	M10
			MANUAL	16
INCLUDING: OPERATION,INSTALLATION& MAINTENANCE			Released:	2/86
Tool Products			Revised:	1-20-95
“0” SERIES	DIE GRINDER	(SHORT GRINDER)	Form:	2884-2
Models:	7015-11-(), 8212-1B-( ) and 8213-1B.

WARNING

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

FAILURE TO OBSERVE THE FOLLOWING

To aid the operator’s understanding of proper and safe use of grinders, the publications, “Use, Care and Protection of Abrasive Wheels”, A.N.S.I. 87.1, and “Safety Code for Portable Air Tools”, A.N.S.I. 8186.1, can be purchased from:

American National Standards Institute, Inc.

1430 Broadway

New York, New York 10018

WARNINGS COULD RESULT IN INJURY.

lUse only medium and high strength mounted wheels.

lDo not use excessive work pressure.

lAllow only people who have received training in “propergrind-

er operation” to operate grinder.

lDo not remove any labels. Replace any damaged label. l Use only accessories recommended by ARO.

l

l

l

l

l l l

l

l l

l

Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure at the air inlet of the tool.

Disconnect air supply from tool before removing/installing mounted wheel, mounted stone or performing other mainte- nance procedures.

Keep hands, clothing and long hair away from rotating end of tool.

Anticipate and be alert for sudden changes in motion during start up and operation of any power tool.

Never exceed rated r.p.m. of tool.

Wear suitable eye and hearing protection while operating tool. Tool shaft can continue to rotate briefly after throttle is re- leased.

Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel.

Use tool only for purposes for which it was intended.

Never use mounted stone or carbide burr with speed rating lower than r.p.m. rating of tool.

Use only mounted wheels of the A, B and W shapes.

Repeated prolonged operator exposure to vibrations which may be generated in the use of certain hand-held tools may produce Raynaud’s phenomenon, commonly referred to as Whitefinger disease. The phenomenon produces numbness and burning sensations in the hand and may cause circulation and nerve dam- age as well as tissue necrosis. Repetitive users of hand-held tools who experience vibrations should closely monitor duration of use and their physical condition.

The use of other than genuine ARO replacement parts may result in safety hazards, decreased tool performance and in- creased maintenance and may invalidate all warranties.

ARO is not responsible for customer modification of tools for applications on which ARO was not consulted.

Tool maintenance and repair should be performed by autho- rized, trained, competent personnel. Consult your nearest ARO authorized servicenter.

It is the responsibility of the employer to place the information in this manual into the hands of the operator.

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution Center, White House, TN at PH: (615) 672-0321, FAX: (615) 672-0601.

ARO Tool Products

Ingersoll-Rand Company

1725 U.S. No. 1 North l P.O. Box 8000 l Southern Pines, NC 28388-8000

01995 THE ARO CORPORATION . PRINTED IN USA.

Part of worldwide Ingersoll-Rand