Ingersoll-Rand 8274-( )A 8276-( )A manual Motor Housing & Exhaust Manifold, Motor ASS’Y

0 TORQUE TO 28 IN. LBS

ROLL PIN Yl76-23

33709 BEARING (FLUSH

33705 BEARING 34466 END PLATE33701 SPACERFACE--INSTALL WITH FLUSH FACE TOWARDS END PLATE)

33700 SEMS FASTENER 0

					33694		NUT
					TORQUE TO 9- I2 FT LBS
		INCLUDED WITH 38301	38302-1	MOTOR	ASS’Y
X	NOT	INCLUDED WITH MOTOR	USED WITH	MODELS	8273-(	)A
			0 TORQUE TO 28 IN. LBS	33709	BEARING (FLUSH
33705		BEARING	33701 SPACER
				FACE--INSTALL		WITH	FLUSH
33711 SPACER	*			FACE	TOWARDS	END	PLATE)
					-- 33700	SEMS	FASTENER

						TORQUE TO 9- 12 FT LBS.
f	INCLUDED	WITH 344	41520 BLADES	4 I523	MOTOR	ASS’Y.
* NOT	INCLUDED	WITH MOTOR ASS’Y.		USED WITH	MODELS	8274-c )A
33705	BEARING	+ ROLL	PIN (2) Yl7B-20		33709	BEARING	(FLUSH
			33701	SPACER
					FACE-INSTALL		WITH FLUSH
					FACE TOWARDS		END	PLATE)
							S	FASTENER 0

33699 SPACER	35679 CYLINDER	33710 END	PLATE
f INCLUDED WITH 35673	CYLINDER		41522	MOTOR	ASS’Y
* NOT INCLUDED WITH MOTOR ASS’Y.		0 TORQUE TO 28 IN. LBS	USED WITH	MODELS	8276-l	)A

MOTOR HOUSING & EXHAUST MANIFOLD	FIGURE:
43874-1	(SINGLE DIRECTION MODELS)
43551-3	(REVERSIBLE MODELS)
INCLUDES 35967 GREASE FITTING (NOT SHOWN)

42339 GASKET(2)

37891 HOUSING (BOLT-ON)*

Y325-129 “O” RING

NOTE: it may be necessary to use one or more Gaskets (42338) to prevent binding of motor assembly when bolting motor housing

to gearing.

DISASSEMBLY

a.To remove Manifold, remove head and “0” Ring (Y325-129) and slip manifold off housing.

39655 MANIFOLD

POSITIONMANIFOLDWITHMUFFLERAPPROXIMATE- LY 180° FROMEXHAUSTSLOTSIN CYLINDER

------

FIGURE 6

REASSEMBLY

a.Assemble Manifold and “0” Ring (Y325-129) to hous-

ing.

NOTE: On models with bolt-on type gearing it may be necessaryto use one or more Gaskets (42338) to prevent bin- ding of motor assembly when bolting motor housing to gear- ing.

-7-