DISASSEMBLY AND REASSEMBLY OF TOOLS
Before starting to disassembleor reassemblethis tool (any part or completely) be sure to read Maintenance Section.
To minimize the possibility of parts damage and for conve- nience, the steps for disassembly or reassembly listed on the following pagesare recommended.
The basic sections and instructions for removing them from tool are as follows:
With tool disconnected from air service-
GEARING SECTION
To remove drive gearing, remove Nuts
To remove “2200” series gearing, remove Cap Screws
MOTOR SECTION
To remove Motor assembly, remove Cap Screws
HEAD SECTION
To remove head from motor section; place head of tool in a suitable holding device and, using a strap wrench, unscrew motor housing from head.
TYPICAL CROSS-SECTION OF TOOL
FIGURE 1
