Ingersoll-Rand 8315 specifications Operating and Safety Precautions, AIR Supply Requirements

OPERATOR’S MANUAL

INCLUDING:OPERATION,INSTALLATION& MAINTENANCE		Released:	8/77
Tool & Hoist Products MARKING	PEN	Revised:	8-2-93
	Model 8315	Form:	1035-2

IMPORTANT: READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

OPERATING AND SAFETY PRECAUTIONS

Pneumatic tools should always be installed and used in accor- dance with A.N.S.I. R186.1 “Safety Code For Portable Air Tools.”

CAUTION:

lKeep hands and clothing away from working end of tool.

lWear suitable eye protection while operating tool.

lUse tool only for purposes for which it was intended.

lSHUT OFF and DISCONNECT AlR SUPPLY from tool BE- FORE performing maintenance, service or disassembly of tool.

WARNING: Repeated prolonged operator exposure to vibrations which may be generated in the use of certain hand-held tools may produce Raynaud’s phenomenon, commonly referred to as Whitefinger disease. The phenomenon produces numbness and burning sensations in the hand and may cause circulation and nerve damage as well as tissue necrosis. Repetitive users of hand-held tools who experience vibrations should closely moni- tor duration of use and their physical condition.

AIR SUPPLY REQUIREMENTS

For maximum operating efficiency, the following air supply specifi- cations should be maintained to this air tool:

lAIR PRESSURE - 90 PSIG (6 bar) l AIR FILTRATION - 50 micron

. LUBRICATED AIR SUPPLY

l HOSE SIZE - 1/8” (3 mm) I.D.

An AR0® model 128121-300 air line FILTER/REGULATOR/LU- BRICATOR (F.R.L.) is recommended to maintain the above air supply specifications.

NOTE: Marking pen operates effectively at 50 - 70 p.s.i.g.

ROUTINE LUBRICATION REQUIREMENTS

Lack of or an excessive amount of lubrication will affect the perfor- mance and life of this tool. Use only recommended lubricants at below time intervals:

EVERY 8 HOURS OF TOOL OPERATION - Fill lubricator reser- voir of recommended F.R.L. with spindle oil (29665). If an in line or air line lubricator is not used, apply several drops of spindle oil (29665) in air inlet.

EVERY 40 HOURS OF TOOL OPERATION - Flush tool with a solution of three (3) parts cleaning solvent to one (1) part spindle oil. After flushing, apply a small amount of spindle oil in air inlet and run free for one minute.

RECOMMENDED LUBRICANTS

Afterdisassembly is complete, all parts, except sealed or shielded bearings, should be washed with solvent. To relubricate parts, or for routine lubrication, use the following recommended lubricants:

Where Used		ARO Part #	Description
Air	Motor	29665	1 qt. Spindle	Oil
“0” Rings	& Lip Seals	36460	4 oz. Stringy Lubricant

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Dis- tribution Center, White House, TN at PH: (615) 672-0321, FAX: (615) 672-0601.

ARO Tool & Hoist Products

Ingersoll-Rand	Company
1725 U.S. No. 1 North		P.O. Box 8000 l Southern Pines, NC 28388-8000
© 1993 THE ARO	CORPORATION.	PRINTED IN U.S.A.

INGERSOLL-RAND®

PROFESSIONALTOOLS