Ingersoll-Rand 84792( ), 84802( ), 84791( ) Warning Label Identification, Sander Specific Warnings

WARNING LABEL IDENTIFICATION

M12

15

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

WARNING

Always wear eye protection when operating or perform- ing maintenance on this tool.

WARNING

Always wear hearing protection when operating this tool.

WARNING

Always turn off the air sup- ply and disconnect the air supply hose before install- ing, removing or adjusting any accessory on this tool, or before performing any maintenance on this tool.

WARNING

Air powered tools can vibrate in use. Vibration, repetitive motions or uncomfortable po- sitions may be harmful to your hands and arms. Stop using any tool if discomfort, tingling feeling or pain occurs. Seek medical advice before resum- ing use.

WARNING

Keep body stance balanced and firm. Do not overreach when operating this tool.

	WARNING
	Do not carry the tool by
	the hose.
90 psig	WARNING
	Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
	620 kPa) Maximum air pressure.

WARNING

Do not use damaged, frayed or deteriorated air hoses and fittings.

WARNING

WARNING
Read the manual before
operating this tool.
Operate at 90 psig/6.2 bar max.
PN 48176–1 LABEL	PN 49883 LABEL

(NON–EU MODELS) (–EU MODELS)

This label must appear on the tool at all times. If it is lost or

damaged, a replacement label is available at no cost.

SANDER SPECIFIC WARNINGS

•Use only a sanding pad, buffing wheel or polishing bonnet with these tools. Do not use any grinding wheel, bur or metal removing accessory other than a sanding pad with these tools. Never use an accessory having a maximum operating speed less than the free speed of the Sander in which it is being used.

•These Sanders will operate at the free speed specified on the nameplate if the air supply line furnishes 90 psig (6.2 bar/620 kPa) air pressure at the tool. Operation at higher air pressure will result in excessive speed.

•Do not operate this Sander away from the work surface.

•Check for excessive speed and vibration before operating.

•Do not use this tool if actual free speed exceeds the nameplate rpm.

•Never exceed the rated rpm of tool.

•Whenever the Angle Head is installed or repositioned, the Throttle Lever must be

positioned so that reaction torque will not tend to retain the throttle in the “ON” position.

•Repeated prolonged operator exposure to vibrations which may be generated in the use of certain hand–held tools may produce Raynaud’s phenomenon, commonly referred to as Whitefinger disease. The phenomenon produces numbness and burning sensations in the hand and may cause circulation and nerve damage as well as tissue necrosis. Repetitive users of hand–held tool who experience vibrations should closely monitor duration of use and their physical condition.

•When using a pad having a shank, insert the shank to full depth in the collet. When using a pad on a threaded arbor, make certain the flange nut is tightened securely. Check the tightness of the collet nut or flange nut before operating a Sander to make certain it will not loosen during operation.

2