Ingersoll-Rand SMB020, SMB050, SMB015, SMB030, SMB005, SMB010 manual Installation

			Hoist				Lift				Hand Chain				Slip
Series					(Hoist load chain/						(Hand chain is 2 ft
			Capacity												Clutch
						hook travel)					less than lift)
SMB= Silver Series		005	= 1/2 metric ton / 500 kg		10	=	10 ft (3 m)		8		= 8 feet (standard)			V = Slip Clutch
Manual		010	= 1 metric ton / 1,000 kg				(standard)				(10 foot lift minus 2 ft)				(standard)
Chain Hoist		015	= 1-1/2 metric ton /		15	=	15 ft (5 m)		13		= 13 feet
			1,500 kg		20	=	20 ft (6 m)				(15 foot lift minus 2 ft)
		020	= 2 metric ton / 2,000 kg		XX =		Specify length		18		= 18 feet
		030	= 3 metric ton / 3,000 kg		F	=	Hoist without				(20 foot lift minus 2 ft)
		050	= 5 metric ton / 5,000 kg				load chain			XX = Specify length
General Specifications
	Rated				Load			Hand Chain				No. of	Hoist Net Weight with
			Pull to Lift Rated Load					Overhauled to Lift						Standard 10 ft (3 m)
	Capacity
Model No.					Chain Size			Load 1 ft (0.3 m)				Chain			Lift
	(metric
					(mm)							Falls
	tons)*		lb	kg				ft			m			lb		kg
SMB005	1/2		55.5	25	5 x 15			31.5			9.6		23.5			10.7
SMB010	1		64	29	6 x 18			53.1			16	1	26.8			12.2
SMB015	1-1/2		69	31	7 x 21			71.6			22		38.5			17.5
SMB020	2		77	35	8 x 24			84.6			26	1	42.4			19.3
SMB030	3		100	45	10 x 30			99.4			30		70.4			32
SMB050	5		83.5	38	9 x 27			213.2			65	2	90.2			41

* One metric ton = 2,200 lbs.

INSTALLATION

Prior to installing the hoist, carefully inspect it for possible shipping damage.

Hoists are supplied fully lubricated from the factory. Lubrication of the load chain is recommended before initial hoist operation.

(Dwg. MHP0832)

WARNING

•A falling load can cause injury or death. Before installing, read “SAFETY INFORMATION”.

CAUTION

•Owners and users are advised to examine specific, local or other regulations, including American Society of Mechanical Engineers and/or OSHA Regulations which may apply to a particular type of use of this product, before installing or putting hoist to use.

Hoists are designed to provide a 4:1 safety factor. The supporting structures and load-attaching devices used in conjunction with this hoist must provide adequate support to handle all hoist operations, plus the weight of the hoist and attached equipment. If in doubt, consult a registered structural engineer.

The SMB manual chain hoist must be used in a vertical position to provide a straight line pull from top hook to bottom hook. The hoist must be positioned so that it does not contact the support members when in use. When operating in limited areas suitable lifting attachments or slings must be used to prevent the hoist body and hand chain from being obstructed.

4 MHD56391 - Edition 2