57
NS-29D310NA15 Insignia 29" LED TV
www.insigniaproducts.com
Changing channel settings

Automatically scanning for channels

When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press CH
or CH , your TV goes to the next or previous
channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
1Press MENU. The on-screen menu opens.
2Press W or X to highlight CHANNELS, then press T
or ENTER. The CHANNELS menu opens.
3Press S or T to highlight Auto Channel Search,
then press ENTER. The CHANNELS· AUTO CHANNEL
SEARCH screen opens.
4Press S or T to highlight Antenna, Cable Service,
or Satellite Service, then press ENTER.
AIf you select Antenna, your TV scans for
available channels. The scan may take several
minutes.
BIf you select Cable Service, a message asks if
you have a cable box:
• Select No, then press ENTER if no ca ble box
is connected. Your TV scans for available
channels. The scan may take several minutes.
• Select Ye s, then press ENTER if a cable box is
connected. A message asks how you
connected the cable box to your TV.
• Select HDMI, Component, or AV, then
press ENTER if you connected a cable box
to your TV using one of these cables.
Read the message, then press ENTER to
close the wizard.
• Select Coaxi al, then press ENTER if you
connected a cable box to your TV using a
coaxial cable. Read the message, then
press ENTER to start the channel scan
(VHF channels only).
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.