Insignia
Component input | Y: 1 | FCC warning | |||
| Pr/Cr: ±0.35 |
| Changes or modifications not expressly approved by the | ||
| Pb/Cb: ±0.35 |
| party responsible for compliance with the FCC Rules could | ||
| Audio: 500 mV(rms) |
| void the user’s authority to operate this equipment. | ||
| Cables | ||||
| Suggested resolutions: 1080i, 720p, 480p, | ||||
| 480i |
|
| Connections to this device must be made with shielded | |
|
|
|
| ||
HDMI input | 3 HDMI input terminal |
| cables with metallic RF/EMI connector hoods to maintain | ||
| HDCP compliant |
| compliance with FCC Rules and Regulations. | ||
|
|
|
| ||
|
|
|
| ||
| Suggested scan rates: |
|
|
| |
|
|
|
| ||
| • | 1080i | Manufactured under license from Dolby Laboratories. “Dolby” and | ||
| • | 720p | the | ||
| • | 480p |
|
|
|
| • | 480i |
|
|
|
|
|
|
|
| |
VGA input |
|
|
| ||
|
|
|
| ||
| Suggested scan rates: |
|
|
| |
| • 640 × 480 @ 60 Hz |
|
|
| |
| • 800 × 600 @ 60 Hz |
|
|
| |
| • 1024 × 768@ 60 Hz |
|
|
| |
| • 1360 x 768 @ 60 Hz, |
|
|
| |
| Audio input: Headphone |
|
|
| |
| stereo |
|
|
|
|
|
|
|
|
| |
Dimensions | 35.75 × 25.04 × 10.24 inches |
|
|
| |
(with base) | (90.8 × 63.6× 26.0 cm) |
|
|
| |
|
|
|
|
| |
Weight | 35.2 lbs. (16 kg) |
|
|
| |
|
|
|
|
|
|
Accessories | • | Power cord |
|
|
|
•User guide
•Remote control
•Batteries (2 AAA)
•VGA cable
•PC audio cable
•Quick Start guide
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced technician for help.
15 |