InSinkErator Water Dispenser owner manual Warranty Information

F201 Chemical & Mechanical Reduction Filter Specifications:

(Use replacement cartridge F-201R) This cartridge (included with the system) provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.

System is tested and certified by NSF International against ANSI/NSF Standard 42 for the reduction of Particulate Class I, Chlorine Class I, Taste and Odor.

Pressure: 30-125 psi

Temperature: 33˚F–100˚F

Flow Rate: 0.75 gpm

Capacity: 500 gallons

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under standard laboratory conditions, actual performance may vary.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty card for warranty. For service and parts, contact your local dealer or In-Sink-Erator directly at 1-800-558-5700.

Contaminant	Average	Product	Average	USEPA	NSF
Reduction	Influent ppm	Water ppm	Reduction	Recommendation	Test
Taste/Odor/	2.10	0.05	97%	N/A	500180-00
Chlorine
Particulates	286667	1683	99%	N/A	500181-00

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F . Except as noted, all testing performed at pH = 7.5±0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp:20˚±3˚C.

Contact an authorized In-Sink-Erator service agent for repairs or replacement components.

Warranty Information

Full 1 Year Warranty: Covers all replacement parts and repair labor to correct defects in material or workmanship in the filter system, excluding the replaceable filter cartridge, for the full warranty period from the date of installation in your home. If warranty service is required during the warranty period, contact an authorized In-Sink-Erator service agent to replace or repair the unit in your home at no cost to you.

This warranty gives you specific legal rights and you may also have other rights which vary. If the manufacturer determines that the unit should be replaced rather than repaired, the warranty on the replacement unit will be limited to the unexpired term of the original warranty. No other expressed warranty, written or oral, applies.

Warranty is determined by the serial number of the unit installed and the date of installation. A purchase or installation receipt may be required to verify warranty status. The foregoing warranty does not apply to damage or inoperation resulting from accident, alteration, misuse, abuse, improper installation, any installation not in accordance with these instructions, or installations not in accordance with local plumbing codes. We do not assume any consequential damage. Warranty will be voided if installed in a commercial or industrial situation.

If you have questions concerning your unit or when service is needed, please call for the name of the nearest authorized service center.

If Your Unit Does Not Operate, contact your authorized service center or In-Sink-Erator.

When writing or calling, give the following information: date, your name, address and phone number. Describe the product by model number, serial number, date purchased, place purchased, service history (include name and address of service agent) and clearly describe the problem and service required.