Integra ADM-2.1 Front panel facilities and connections, Power, Standby/On indicator

Front panel facilities and connections

Power

On Off

Standby/On

ADM-2.1

Power When the TRIGGER switch is set to AUDIO

After plugging in the power cord into the rear panel and wall outlet, pressing this switch connects the ADM-2.1 to the AC mains. The function of this switch differs depending on the setting of the TRIGGER switch on the rear panel. Before turning on the power, be sure to set the TRIGGER switch. Besides, before turning on the power, make sure all cables are properly connected.

The TRIGGER switch is factory set to OFF.

When the TRIGGER switch is set to OFF

Pressing the Power switch turns on the ADM-2.1. The Standby/On indicator lights orange after flashing red for 5 seconds.

Press the Power switch again to turn off the ADM-2.1.

When the TRIGGER switch is set to 12V TRIGGER

If no signal is supplied to the 12V TRIGGER IN jack, pressing the Power switch enters the standby state and the Standby/On indicator lights red.

If 12V DC is supplied to the 12V TRIGGER IN jack, pressing the Power switch turns on the ADM-2.1 and the Standby/On indicator lights orange after flashing red for 5 seconds.

If the ADM-2.1 is in the standby state, the ADM-2.1 turns on automatically when 12V DC is supplied to the 12V TRIGGER IN jack.

When the signal input to the 12V TRIGGER IN jack is interrupted, the indicator lights red and the ADM-2.1 enters standby state (Auto Power On/Off Function).

Press the Power switch to turn off the ADM-2.1.

If no signal is supplied to the AUDIO IN jacks, pressing the Power switch enters the standby state and the Standby/On indicator lights red after flashing red for 5 seconds.

If an audio signal is supplied to the AUDIO IN jacks, pressing the Power switch turns on the ADM-2.1 and the Standby/On indicator lights orange after flashing red for 5 seconds.

If the ADM-2.1 is in the standby state, the ADM-2.1 turns on automatically when an audio signal is supplied to the AUDIO IN jacks.

When the signal input to the AUDIO IN jacks is not supplied for more than 4 minutes, the indicator turns to red and the ADM-2.1 enters standby state (Auto Power On/Off Function).

Press the Power switch to turn off the ADM-2.1.

Note:

You cannot use the Auto Power On Function when the power is turned off. To use the Auto Power On Function, leave the ADM-2.1 in the standby state once the ADM-2.1 enters the standby state.

Standby/On indicator

The Standby/On indicator lights red when the ADM-2.1 is in the standby state and lights orange when the ADM-2.1 is turned on.

6

#US_ADM-2.1_04-07.p65 6 8/25/00, 6:22 PM