Integra DTR-4.5 instruction manual Speaker Connection Precautions, Connecting the Speaker Cables

Connecting the AV receiver—Continued

Speaker Connection Precautions

Read the following before connecting your speakers:

•Only connect speakers with an impedance of 6 ohms or higher. If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the built-in protection circuit may be activated.

•Disconnect the power cord from the wall outlet before making any connections.

•Read the instructions supplied with your speakers.

•Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals to only positive

(+) terminals, and negative (–) terminals to only nega- tive (–) terminals. If you get them the wrong way around, the sound will be out of phase and will sound unnatural.

•Unnecessarily long, or very thin speaker cables may affect the sound quality and should be avoided.

•Be careful not to short the positive and negative wires.

Doing so may damage the AV receiver.

• Don’t connect more than one cable to each speaker termi-

nal. Doing so may damage the AV receiver.

• Don’t connect one speaker to several terminals.

Connecting the Speaker Cables

1	Strip about 5/8" (15 mm)	5/8" (15 mm)
	of insulation from the
	ends of the speaker
	cables, and twist the bare
	wires tightly, as shown.
2	Unscrew the terminal.
3	Fully insert the bare
	wires.
4	Screw the terminal tight.

The following illustration shows which speaker should be connected to each pair of terminals.

Surround	Surround
left speaker	right speaker

ZONE 2 SPEAKERS SURROUND SPEAKERS

L

L

R

R

L

CENTER SPEAKER

R

FRONT SPEAKERS

Front left	Front right	Center
speaker	speaker	speaker

22