Intel Desktop Board DX48BT2 Product Guide

1.Observe the precautions in "Before You Begin" on page 27.

2.Connect the 12 V processor core voltage power supply cable to the 2 x 4 pin connector. Use the 2 x 2 to 2 x 4 adapter if need.

NOTE

Do not use the included 2 x 2 to 2 x 4 adapter when using an Intel® Pentium® processor Extreme Edition or other Intel processor that is not running at its default settings. Doing so may result in damage to the Desktop Board.

3.Connect the 1 x 4 power supply cable to the 1 x 4 connector.

4.Connect the main power supply cable to the 2 x 12 pin connector.

Setting the BIOS Configuration Jumper

NOTE

Always turn off the power and unplug the power cord from the computer before moving the jumper. Moving the jumper with the power on may result in unreliable computer operation.

Figure 31 shows the location of the Desktop Board’s BIOS configuration jumper block.

Figure 31. Location of the BIOS Configuration Jumper Block

The three-pin BIOS jumper block enables all board configurations to be done in the BIOS Setup program. Table 14 shows the jumper settings for the BIOS Setup program modes.

56

Page 56
Image 56
Intel DX48BT2 manual Setting the Bios Configuration Jumper, Location of the Bios Configuration Jumper Block