PX865PE7 PRO/ PX865PE7
32
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2) 、3E8/IRQ4、
Red (IR) standard to be used.
IrDA
s the RxD and TxD frequencies. This field only configurable if “UART Mode
y the IR interface. Full-duplex mode permits simultaneous
Use IR Pins
mentation to select the correct setting of the TxD and RxD signals.
d
rallel Port.
r Port.
ly configurable if “Parallel Port Mode” is set to “EPP”
2E8/IRQ3、Auto
UART Mode Select
This item allows you to select the Infra
Options: Normal (default)、ASKIR、
RxD, TxD Active
This item determine
Select” is set to “ASKIR” or “IrDA”. Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. This field only configurable if “UART
Mode Select” is set to “ASKIR” or “IrDA”. Options: Enabled (default)、Disabled
UR2 Duplex Mode
Select the transmission mode used b
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: Half (default)、Full
Consult your IR peripheral docu
This field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: Full、Half (default)
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disable
Parallel Port Mode
This option allows you to select a parallel port mode for the onboard parallel port.
abilities Port. Options: ECP(default) Extended Cap
EPP nhanced Pa E
SPP Standard Printe
ECP+EPP ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. This field is on
or “ECP+EPP”. Options: EPP 1.9(default)、EPP 1.7