Intel SRCSASPH16I manual Technical Specifications

Table 1. Jumper Descriptions

Jumper	Description	Type	Comments
J6	Dirty Cache LED	SFF8087	For connection to enclusure LED. When lit,
	Header		indicates the data in the cache has not been
			written to disk.
J9	Internal SAS/SATA	SFF8087	Connection to SAS/SATA devices.
	port connector,
	ports 4-7
J11	Mode 0 select	2-pin	No jumper is required for normal operation.
		connector	Setting the controller to Mode 0 holds the I/O
			processor in reset for firmware recovery.
			• "No Jumper = Normal operational mode.
			• "Jumper = Mode 0 for firmware recovery,
			requires a firmware recovery utility and
			firmware image file.
J12	Universal	4-pin	For factory and debug use.
	Asynchronous	connector
	Receiver/
	Transmitter (UART)
J13	Internal SAS/SATA	SFF8087	Connection to SAS/SATA devices.
	port connector,
	ports 0-3
J14	Drive Fault LED	8x2 header	LED signal support for front panel drive fault per
	Header (0-7)		port (0-7).
J15	Port activity LED	8x2 header	LED signal for activity per port for 0-7 ports.
	header (0-7)
J16	Intel® RAID Smart	20-pin	Cable connector for the extrernal battery pack.
	Battery Connector	connector	This connector is located on the back side of the
			board.
J17	Keyed I2C	3-pin	Out-of-band enclosure management (SES2).
	connector	connector
J18	Keyed I2C	3-pin	Out-of-band enclosure management (SES2).
	connector	connector

Technical Specifications

The design and implementation of the Intel® RAID Controller SRCSASPH16I minimizes electromagnetic emissions, susceptibility to radio frequency energy, and the effects of electrostatic discharge. See the appendices for regulatory marks and certifications.

13 Intel® RAID Controller SRCSASPH16I Hardware Guide