Intel XP-P4S8X-VM user manual MB Intelligent TweakerM.I.T

English

3.8.MB Intelligent Tweaker(M.I.T.)

øThis allows user to configure CPU frequency and voltage settings.

CMOS Setup Utility-Copyright (C) 1984-2005 Award Software

MB Intelligent Tweaker(M.I.T.)

	Configure DRAM Timing		[Auto]				Item Help
x	Cas Latency Setting		2.5T			Menu Level}
x DRAM RAS Active Time			7T
x	DRAM RAS Precharge Time		3T			[AUTO]
x	DRAM RAS to CAS Delay		3T			Configure DRAM
	CPU Clock Ratio		[21X]			Timing automatically
	Linear Frequency Control		[Disabled]
x	CPU Clock (MHz)		133			[Normal]
x	DRAM Clock (MHz)		AUTO			Configure DRAM
	AGP/PCI Clock Control		[AUTO]			Timing by manual
x	AGP Clock (MHz)		66
x	PCI Clock (MHz)		33			Warning: Wrong DRAM
						Timing may make
						system can't boot.
						Clear CMOS to overcome
						wrong Timing issue
higf: Move		Enter: Select	+/-/PU/PD: Value	F10: Save	ESC: Exit		F1: General Help
	F5: Previous Values		F6: Fail-Safe Defaults		F7: Optimized Defaults

øThis section is very dangerous for inexperienced users, and therefore it is not recommended that these settings be altered. An incorrect setting can result in system instability, corrupt data, or permanent hardware damage.

nConfigure DRAM Timing

Allows user to set up DRAM Timing. (default:Auto)

Options: Auto (sets DRAM Timing by DRAM SPD data automatically) Manual (sets DRAM Timing manually)

nCas Latency Setting

Options:	Auto (automatically sets Cas Latency) (default:Auto)
	2T, 2.5T, 3T (selects Cas Latency as user require)

nDRAM RAS Active Time

Options: Auto (automatically sets DRAM RAS Active Time) (default:Auto)

4T, 5T, 6T, 7T, 8T, 9T (selects DRAM RAS Active Time as user require)

nDRAM RAS Precharge Time

Options: Auto (automatically sets DRAM RAS Precharge Time) (default:Auto) 3T, 2T, 4T, 5T (selects DRAM RAS Precharge Time as user require)

nDRAM RAS to CAS Delay

Options: Auto (automatically sets DRAM RAS to CAS Delay) (default:Auto) 3T, 2T, 4T, 5T (selects DRAM RAS to CAS Delay as user require)

nCPU Clock Ratio

Allows user to set the CPU Clock Ratio.

If the CPU used locks this feature, then it will not be displayed or will not function. (based on CPU type)

nLinear Frequency Control

Allows user to use Linear Frequency Control. (default:Disabled)

nCPU Clock (MHz)

If you wish to use this feature, please set the "Linear Frequency Control" to Enabled. If this feature is disabled, the currently CPU Clock will be displayed.

The CPU Clock can be input between 100MHz to 355MHz.

If you have a FSB400 Pentium 4 CPU, please set the "CPU Clock" to 100MHz. If you have a FSB533 Pentium 4 CPU, please set the "CPU Clock" to 133MHz.

22