5. INSTALLATION
UNPACKING
The carton contains the following :
•Telephone body and handset
•Coiled cord and line cord
•This User Manual.
SETTING THE FLASH TIME
Set the TBR TIMING SWITCH to suit the PABX or host system’s required flash time. This setting is needed to ensure correct operation of the Recall key on the top panel. The settings available are - 100mS, 600mS. (see figure 4)
GENERAL SETTING-UP
1.Fit the COILED CORD to the appropriate sockets in the HANDSET and the telephone base
2.Fit the LINE CORD to the rear socket and to your telephone network outlet
3.Set the Ringer Volume and Ringer Pitch controls
4.See following sections to complete the installation.
5.Set handset polarity switch “normal” to use the handset, or set the switch to “reversed” position if you are using a headset that is wired to suit this setting.
LOCATION
The telephone should be placed on a desk, table or shelf where it is not likely to be pushed off. If the unit is to be wall mounted, it should be seated securely on the WALL MOUNTING BRACKET. Avoid excessive heat, damp, dust, direct sunlight, vibration, and other appliances or devices that may transmit or emit electrical or electromagnetic radio frequency noise or signals (e.g. computers, welders, pagers).
11
