Intex Recreation 88PO SET, UP INSTRUCTIONS

UP INSTRUCTIONS

(88PO) OVAL FRAME POOL ENGLISH 7.5” X 10.5” PANTONE 295U 09/14/2007

88PO

POOL SET UP (continued)

3.Be sure the liner is opened and spread out to its fullest extent on top of the ground cloth. Starting with one side, slide the closed end of “A” beam first into the sleeve openings located near the corner. Continue with “B” beam snapping into the “A” beam, and another “C” beam snapping into the “B” beam.

Keep the metal beam holes aligned with the white liner sleeve holes.

Continue inserting all “A-B-C” beams into the sleeve openings, and do the same on the other side.

The combinations for beams are different for different sizes of pools, see the chart below for detail. (Be sure all sides end up with the metal beam holes aligned with the white liner sleeve holes.)

Size of Pool	No. of “U-shape” Leg on a side		Beam Combinations
18’ x10’ (549 cm x 305 cm) & 20’ x 12’ (610 cm x 366 cm)		2		A-C
24’ x 12’ (732 cm x 366 cm)		3		A-B-C
28’ x 12’ (853 cm x 366 cm)		4		A-B-B-C
4. Slide the restrainer strap (9) onto the large U-shaped		9	11	10	3
side support (12). Repeat for all restrainer straps and
U-supports(see drawing 3).
IMPORTANT: The liner is to remain flat on the
ground during the next step #5. This is why 5 - 6’
of clearance space around the pool is necessary.
			12

SET-

5.• The tops of the U-shaped side supports have a double button spring loaded clip that is factory pre-installed. Insert the side supports into the “A-B-C” beam holes by squeezing the bottom button inward with your fingers.

•Squeezing this bottom button will allow the support to enter the beam. Once the U-support is inside the beam release the finger pressure allowing the support to “SNAP” into place. Repeat this procedure for all U-shaped side supports (see drawing 4).

4

9

11 12

6. Insert the connecting rods into the overlapping

openings, to connect the liner straps to the restrainer straps (see drawing 5).

5

8

SAVE THESE INSTRUCTIONS

Page 10