Invacare 1048085, 1055948 Installing the Camlock, Reassembling the Quad Cane, of cane handle

Installing the Camlock

NOTE: For this procedure, refer to Detail “B” of FIGURE 1.

1.Remove old camlock assembly from upper cane handle.

2.Slide camlock assembly onto bottom of upper cane handle ensuring small tab on top front of camlock housing snaps into small notch on the bottom front of cane handle.

3.Operate cam lever up and down to ensure it opens and closes properly.

Cam Handle		Cut out DETAIL “A” -
		ASSEMBLING
		CAMLOCK
Large	Cam	Recess
	Lever	Cam
Tab
	(Rear)	Lock
		Small Housing
		Tab
Cam Handle		UNLOCK
		LOCK
Cam Lock		Rear of Cam Handle
		Large Tab
Housing
		Cut out

DETAIL “B” -	Upper Cane
INSTALLING
CAMLOCK	Handle
Front
Small Notch on front	Rear
of Cane Handle.	Large
(Not Shown).
	Notch
Small Tab	UNLOCK
Camlock
Assembly	LOCK
Cam Lever

NOTE: Raise Cam Lever before installing Camlock Assembly

FIGURE 1 Assembling the Camlock

Reassembling the Quad Cane

NOTE: For this procedure, refer to FIGURE 2.

1.	Raise cam lever before installing upper	Upper Cane
	cane handle onto base.	Handle
2.	Re‐install cane handle with new
	camlock assembly onto cane base.
3.	Push cam lever down.
NOTE: This will engage the large tab on		Base
bottom rear of cam lever into large notch on rear

of cane handle.

Camlock Assembly

Cam

Lever

4.Test cane to ensure that cane and camlock assembly are properly secured, i.e., no rattle or looseness of the cane base and upper cane handle.

NOTE: Push Cam Lever down after re‐installing upper cane handle to base.

FIGURE 2 Reassembling the Quad Cane

		Invacare Corporation	www.invacare.com
		USA	Canada
		One Invacare Way	570 Matheson Blvd E Unit 8 Invacare, Yes, you can. and the Medallion
		Elyria, Ohio USA	Mississauga Ontario	Design are registered trademarks of
	44036-2125		L4Z 4G4 Canada	Invacare Corporation.
	800-333-6900		800-668-5324	©2006 Invacare Corporation
Quad Cane Camlock	Replacement Kit		2	Part No 1055947	Part No 1055947

Rev B - 10/12/06