5
1. Connect the spade connector wires to the motor
in the following manner:
A. BLACK spade connector wire to lower spade.
B. RED spade connector wire to upper spade.
CAUTION
DO NOT secure the pendant cable be-
yond the middle of the cable (measur-
ing from the current limit device to the
pendant), otherwise damage to the
cable may result.
.
2. Secure the pendant cable and the spade connec-
tor wire wrap to the motor with the mounting bracket
as shown in FIGURE 8.
3. Align the mounting holes of the mounting bracket and
motor and secure the mounting bracket with the two
(2) EXISTING mounting screws. Tighten securely.
4. Position the motor shroud over the motor, aligning the
mounting holes of the motor shroud and motor.
5. Install the machine screw and washer in the side
mounting hole. Tighten securely.
6. Install the two (2) self-locking screws and two (2)
washers in the front mounting holes. Tighten securely.
7. Grasp the handgrip on the battery pack and push
downwards to install it onto the motor shroud.
WARNING
To prevent frame from tipping when raising
the bath lift without the seat installed, ei-
ther suction the frame to the floor or place
one foot on the frame base.
8. Secure the frame to the floor with the suction cups or by
standing on the frame base.
9. Test the operation of the bath lift by pressing the
UP and DOWN buttons on the pendant to ensure
proper installation of the NEW pendant.
10. Perform one (1) of the following:
PROPER OPERATION - Install the bath lift
frame into the bathtub. Refer to INSTALLING
BATH LIFT INTO THE BATHTUB in this in-
struction sheet.
IMPROPER OPERATION - If the bath lift does
not respond correctly when the pendant but-
tons are pushed (for example, the lift raises
when the DOWN button is pushed) or if it does
not work at all, repeat STEPS 1-9 making sure
the spade connectors are properly connected.
NOTE: If improper operation exists, contact
Invacare at the number on the back of this in-
struction sheet before using.
FIGURE 7 - INSTALLING THE BATTERY
CONNECTOR
DETAIL "F" - STEP 5
DETAIL "E" STEPS 2-3
TIGHTEN
Flathead Screw (DO
NOT REMOVE)
Bare
End of
Wire
Insulated
Wire
BLUE (-)
Wire
Flared End of Battery Connector
YELLOW
(+) Wire
Flat Screws
STEPS 8-10
Yellow (+) Wire
Blue (-) Wire
FRONT
Hole
REAR Hole
REAR of
Motor
Shroud
FRONT of
Motor
Shroud
DETAIL "D" - STEP 1
Mounting
Screws
(Nuts NOT
SHOWN)
Battery
Connector
BLUE (-)
Wire
YELLOW (+) Wire
Flared End
Battery
Connector
NEGATIVE
(-) Channel
POSITIVE (+)
Channel
Installing the Motor Shroud (FIGURE 8)
CAUTION
The spade connectors MUST be con-
nected to the motor as shown in FIG-
URE 8 - otherwise, the pendant will op-
erate improperly.