RIDGID SP6263 manual Attaching Carriage Motor to Arm, Lock miter/arm lock before proceeding

Assembly

Attaching Carriage - Motor to Arm

Remove carriage stop screw, lockwasher and tag. Read and understand warning tag before discarding tag.

Lock miter/arm lock before proceeding.

Holding carriage assembly with both hands, carefully start and slide the carriage onto the tracks. The assembly must be held parallel with the arm so that all four bearings slide smoothly onto the arm, preventing any excessive strain on bearings and track.

WARNING

Reinstall carriage stop screw and lock- washer to prevent carriage from rolling off arm. Tighten carriage stop screw securely.

Note: Remove two (2) motor packing studs that are threaded into bottom of motor.

Packing

Studs

Install arm cap.

WARNING

Make certain power cord is unplugged.

1.Insert finger under left end of switch lever and pull out to the "ON" position.

2.Place arm cap in position and install with

(2) 10-32 x 7/8 self threading screws.

3.Push switch to "OFF" position.

Warning

Tab

Lockwasher

Stop Screw

Hex “L” Wrench 1/4 Inch (Supplied)

Push toward rear of	Miter/Arm
	Lock Lever
saw to lock

Bottom

of Motor

Arm Cap

Screw

Reinstall carriage stop screw and lockwasher

17