SECTION
Removing/Installing the Safety Strap
WARNING
DO NOT put the safety strap in the dryer. The high heat will melt the belt’s material.
NOTE: For this procedure, refer to FIGURE 2.10.
NOTE: The safety strap MUST be washed and disinfected after each use.
1.Unbuckle the safety strap by pulling up the hook‐and‐loop strip on the buckle.
2.Pull the hook‐and‐loop strip through the buckle (Detail “A”).
3.Remove the safety strap from the chair.
4.Repeat STEPS 1 to 3 for the other side.
5.Wrap the new safety strap around the lift frame.
6.Insert the hook‐and‐loop strip through the buckle and secure it to the chair frame (Detail “B”).
7.Repeat STEPS 5 and 6 for the other side.
Chair Frame | Buckle DETAIL “A” |
Chair Frame | Buckle | DETAIL “B” |
|
Safety Strap |
Safety Strap |
FIGURE 2.10 Removing/Installing the Safety Strap
Installing/Removing the Shoulder Strap
NOTE: For this procedure, refer to FIGURE 2.11.
NOTE: To remove the shoulder strap, reverse this procedure.
1.Insert the belt through the bracket at the top of the chair.
2.Loop the hook‐and‐loop strip through the bracket and secure the strap.
Shoulder
Strap
Chair | Hook- |
| |
| |
| Strip |
FIGURE 2.11 Installing/Removing the
Shoulder Strap
Part No. 1148113 | 15 | 1900/1900S Bath Lift |