SECTION
Mounting Bracket (STEP 6)
Mounting Screws (STEP 7)
Battery Charger with
Mounting Bracket
(STEP 5)
BOTTOM
Mounting Screw (STEP 4)
FIGURE 2.8 Mounting the Battery Charger
Charging the Battery
NOTE: For this procedure, refer to FIGURE 2.9.
NOTE: Invacare recommends the battery be recharged daily to prolong battery life.
NOTE: An audible alarm will sound (horn will beep) when battery is low.
1.Lift up on the handle on the back of the battery (Detail “A”).
2.Lift the battery up and out from the control box.
WARNING
Make sure there is an audible click when mounting battery either on the battery charger or the control box to confirm proper mounting. Otherwise, injury or damage may occur.
3.Place the battery on the battery charger (Detail “B”).
NOTE: There will be an audible click.
NOTE: The charge LED will illuminate. When charging is complete, the charge LED will stop illuminating.
NOTE: A battery needing to be fully recharged will take approximately four hours.
4.Lift up on the handle on the back of the battery (Detail “A”).
5.Lift the battery up and out away from the battery charger.
6.Reinstall the battery onto the control box of the lift (Detail “B”).
7.Push the battery into the lift housing and rock slightly until it locks into place (Detail “C”).
NOTE: There will be an audible click when the battery locks into place (Detail “D”).
NOTE: The battery is | Emergency Pull Pin | |
shown being removed |
|
|
from and installed into a |
|
|
control box. Removing |
|
|
and installing a battery |
|
|
into a battery charger is |
|
|
done the same way. |
|
|
DETAIL “A” |
|
|
Handle |
|
|
Battery | Battery | Control Box |
| ||
| DETAIL “B” | |
|
|
|
Battery DETAIL “C” | Battery | DETAIL “D” |
|
|
Control Box | Audible | Control |
Click | Box |
FIGURE 2.9 Charging the Battery
1900/1900S Bath Lift | 14 | Part No. 1148113 |