![](/images/new-backgrounds/1099330/9933053x1.webp)
SECTION
DETAIL “A” | DETAIL “B” |
Models 3600 and 3600XL | Model 3650 |
Tub Fill On/Off Valve
DrainDrain
FIGURE 3.5 Filling Tub
DETAIL “C”
Flow Water Thermometer
Water Temperature
Valve
Hydromassage
CAUTION
Before starting hydromassage, water level MUST be completely above whirlpool jets otherwise severe damage to the motor/pump will result.
NOTE: For this procedure, refer to FIGURE 3.6 on page 27.
1.Close the aerator by rotating the aerator valve two turns clockwise.
2.Open the whirlpool inlet by pushing the inlet plug in.
3.Open all whirlpool jets by pulling the center of the whirlpool jet out or rotating the center counterclockwise (Detail “A”).
4.Fill the tub. Refer to Filling Tub on page 26.
5.After water level covers whirlpool jets and after bathing the resident, add Invacare Defoamer to bath water. Refer to Defoamer bottle for directions.
6.Push whirlpool On/Off (Detail “B”) button to start whirlpool jets.
7.Adjust the whirlpool aerator for desired water agitation by rotating the whirlpool aerator (Detail “C”).
8.After use, push whirlpool On/Off button (Detail “B”) to stop whirlpool jets.
9. Drain tub.
| DETAIL “A” |
| Whirlpool Jet |
Turn Clockwise | Push In To |
to Close | Close |
| Plug |
DETAIL “B”
Whirlpool On/Off
Button
DETAIL “C”
Whirlpool Aerator
FIGURE 3.6 Hydromassage
Part No 1118387 | 27 | Side Entry Whirlpool Tub |