Manuals / Brands / Personal Care / Mobility Aid / Invacare / Personal Care / Mobility Aid

Invacare BUZZ HMV SECTION, OPERATION, OPERATION, DETAIL "A, FIGURE 1 - CONTROL PANEL FEATURES

1 52

Download 52 pages, 2.97 Mb

OPERATION

SECTION 3	OPERATION

4.CHARGING INDICATOR - Located on the top face of the control panel as shown in FIGURE 1. SOLID RED indicates the charger is on (plunged into wall receptacle).

5.IGNITION - Located on right side of the control panel.

6.HORN BUTTON - Located on the front face of the control panel toward the left as shown in DETAIL "A" of FIGURE 1.

7.THROTTLE CONTROL LEVER - Located below control panel as shown in DETAIL "A" of FIGURE 1.

Battery Charge Indicator

Status Indicator	Ignition

Speed Control Knob

Charging Indicator

DETAIL "A"

Horn Button	Throttle
	Control Lever

FIGURE 1 - CONTROL PANEL FEATURES

®	22	Part No. 1118395
®

Contents

Owner's Operator And Maintenance Manual SPECIAL NOTES NOTICE TABLE OF CONTENTS SPECIAL NOTES PRODUCT REGISTRATION FORM SPECIFICATIONS SECTION 1 - GENERAL GUIDELINES REGISTER YOUR PRODUCT PRODUCT REGISTRATION FORM Register ONLINE at www.invacare.com - or Complete and mail this form Name Address Page SPECIFICATIONS OPERATING GUIDELINES WARNINGS (CONTINUED) DO NOT attempt to lift the powered scooter by its tiller, seat or shrouds DO NOT remove key or shut off while the scooter is in motion Manually disconnect/connect cable connections and 2) Remove/install batteries DO NOT stand on the shroud(s) of the powered scooter RAMPS ELECTRICAL GROUNDING INSTRUCTIONS BATTERIES RAIN TEST WEIGHT LIMITATION ELECTROMAGNETIC INTERFERENCE Page SAFETY/HANDLING STABILITY AND BALANCE PERCENTAGE OF WEIGHT DISTRIBUTION STAIRWAYS ESCALATORS WARNING/CAUTION LABEL LOCATION SAFETY INSPECTION CHECKLIST SAFETY INSPECTION CHECKLIST (CONTINUED) MAINTENANCE SUGGESTED MAINTENANCE PROCEDURES LUBRICATION POINTS (FIGURE 1) TROUBLESHOOTING CONTROL PANEL FEATURES (FIGURE 1) Page DETAIL "A FIGURE 1 - CONTROL PANEL FEATURES OPERATION OF THE SCOOTER BRAKE RELEASE LEVER (FIGURE 2) REPLACING THE RESET CIRCUIT BREAKER/FUSE CIRCUIT BREAKER (FIGURE 3)