Invacare Fixed Released Rail/Cane Clamps Quick Release Clamps For Seat Figure, Insert, Detail a

Quick Release Clamps For Seat (FIGURE 2)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

NOTE: The quick release clamps are designed to fit either 1-inch rail tubing or, with insert provided, 7/8-inch rail tubing.

1.Removethesleeve,lockwasher,and internalthreaded mounting screw from the quick release clamp (DE- TAIL “A”) .

2.Place the quick release clamp on the seat rail.

3.Ifquickreleaseclampisnottightlyfittedaroundseatrail tubing,installinsertprovidedasshowninDETAIL “A” .

4.Install the quick release clamp onto the seat rail so that the fixed portion is flush against and rests on top of the mounting hook and the release portion is between the front riggings and the mounting hook.

5.Reinstall the sleeve, lock washer, and internal mount- ing screw into the quick release rail clamp and torque to 75 - inch pounds.

6.Repeat STEPS 1- 5 for other side.

7.Once quick release mounting clamps are secured, do one (1) of following:

A.RefertoTWISTRELEASECLAMPSFORBACK in PROCEDURE 1 of this instruction sheet.

B.Referto USING CLAMPS inthisinstructionsheet.

Insert DETAIL “A”

Lock Washer

Internal

Sleeve Mounting

Screw

Back Cane

Fixed	Release
Portion	Portion

Mounting

Quick Release

Hook

Rail Clamp

FIGURE 2 - QUICK RELEASE CLAMPS FOR SEAT

PROCEDURE 2 - INSTALLING CLAMPS ON SEATING SYSTEMS WITHOUT A GROWTH BRACKET

Twist Release Clamps For Back (FIGURE 1)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

1.Make sure that the back mounting hooks are flush against the back canes.

2.Loosen socket screw that opens twist release clamp.

NOTE: There is a right and left twist release clamp. Make sure when installing that the socket screw adjustment is on the outside of the wheelchair frame.

3.Install the open end of the twist release clamp below the back mounting hook so that the locking mecha- nism rests on top of the mounting hook.

4.Loosely tighten the socket screw.

5.Repeat STEPS 1- 4 for the other side.

6.Make sure both twist release clamps are flush against the back mounting hooks and that the locking mecha- nism rests on top of the back mounting hooks.

7.Torque socket screw to 75 - inch pounds.

8.Once twist release mounting clamps are secured, do one (1) of following:

A.RefertoFIXEDRELEASECLAMPSFOR BACK in PROCEDURE 2 of this instruction sheet.

B.RefertoUSING CLAMPS inthisinstruction sheet.

Fixed Release Clamps For Back (FIGURE 3)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

NOTE: The fixed release rail/cane clamps are designed to fiteither1-inchrailtubingor,withinsertprovided,7/8-inchrail tubing.

1.Remove the mounting screw, lock washer, and inter- nal threaded mounting screw from the fixed release clamps (DETAIL “B”) .

2.Place the fixed release clamp on the back cane.

3.If fixed release clamp is not tightly fitted around back cane tubing, install insert provided as shown in DE- TAIL “A” .

4.Install the fixed release clamp onto the back rail so that the fixed portion is flush against and rests on top of the mounting hook and is located between the seat rail and the bottom of the mounting hook.

2