CURVED BACK
Top of Back
Standard
Bottom of Back
Top of Back | Top of Back |
Option 1 | Option 2 |
Bottom of Back | Bottom of Back |
ULTI-MATE BASE
Front of Base
Standard
Rear of Base
Front of Base | Front of Base |
Option 1 | Option 2 |
Rear of Base | Rear of Base |
FIGURE 2 - ATTACHMENT POINTS
ATTACHING / ADJUSTING THE ADJUSTABLE ANGLE GROWTH BRACKET (FIGURE 3)
Attaching the Adjustable Angle Growth Bracket
NOTE: The growth bracket attaches to the child/junior sized curved back ONLY.
1.Remove the adjustable angle growth bracket and attaching hardware from the packaging.
2.Unzip the center panel of the back cover, exposing the six (6)
NOTE: Make sure that the growth bracket is positioned correctly. The flat portion of the adjustable angle bracket growth bracket provides depth adjustment for the Ulti- mate base. The angled portion of the adjustable angle bracket height adjustment for the curved back (FIGURE 2).
3.Install four (4) of the mounting screws through the slots in the adjustable angle growth bracket and into the underside of the
NOTE: On the
4.Install two (2) of the mounting screws through the slots on the adjustable angle growth bracket and into the back shell. Securely tighten.
NOTE: On the curved back, the standard attachment points are the MIDDLE set of holes. Refer to the FIGURE 2 - ATTACHMENT POINTS in this instruction sheet for optional attachment points.
5.If adjustment is required, refer to ADJUSTING THE GROWTH BRACKET in this instruction sheet.
Adjusting the Growth Bracket
ADJUSTING THE BACK HEIGHT.
1.If necessary, unzip center panel of the back cover.
2.Loosen the two (2) mounting screws that se- cure the growth bracket to the back.
3.Adjust the back up or down until the desired mounting position is obtained.
4.Securely tighten the two (2) mounting screws.
2
