Invacare 6803A, 6815A, 1143214, 6808A, 6816A, 6801A owner manual Using the IH5748A Bed Rails

3.Carefully push the bolt through the mounting hole in the bed frame (Detail “B”).

4.Loosely install the hex nut on the bolt to secure the latch arm to the bed frame (Detail “B”).

5.Loosen and remove the hex nut from the bar closest to the latch arm (Detail “A”).

6.Carefully push the bolt through the corresponding mounting hole in the bed frame (Detail “A”).

7.Loosely install the hex nut on the bolt to secure the bar to the bed frame (Detail “A”).

8.Repeat STEPS 5-7 for the remaining bars.

9.Securely tighten all bolts and hex nuts securing the bars and the foot end latch arm to the bed frame. Torque to 100-150 inch-pounds.

Bars

Refer to Detail “A”

Release Lever

Latch Arm

Bed Frame

Foot End

of Bed

Refer to Detail “B”

DETAIL “A” - BAR HARDWARE

Washer Rubber Bed

DETAIL “B” - LATCH ARM HARDWARE

Spacer Bed

Spacer

Bushing Frame

Frame

			Hex
Bolt	Bearing	Spacer	Nut
	Bar	Bearing

Bolt	Hex Nut
Bar	Spacer

FIGURE 4 Installing/Using Nylasar Bed Rails - Installing the IH5748A Bed Rails

Using the IH5748A Bed Rails

NOTE: For this procedure, refer to FIGURE 5.

1.Perform one of the following:

•Raising - Lift up on the bed rail until the rail locks into place.

•Lowering - Press in on the release lever and push down on the rail.

Foot End of Bed

Bed Rail

Release Lever

FIGURE 5 Using the IH5748A Bed Rails

Part No 1143214 5 ICCG Bed Rails