OPERATION
Normal Battery Charging Procedures
1.Turn the ON/OFF switch to the OFF position (position O).
2.If not already installed, attach the battery pack to the Freeway Lite. Connect the power pack or 12 volt DC lead to the DC power inlet on the Freeway Lite and connect the other end to a suitable power supply (wall or car outlet). The GREEN Charging light will come ON to show that the unit is charging.
CAUTION
Your power supply at the DC inlet MUST BE the correct polarity (Refer to SPECIFICATIONS in this manual). The Freeway Lite will NOT operate or charge batteries from an incorrect polarity DC supply.
NOTE: The Freeway Lite internal control circuit regulates the battery charging. The Freeway Lite battery pack can be charged for as long as you require without damage. It will take approximately 16 hours to recharge a fully discharged battery.
OPERATING YOUR FREEWAY LITE
Power Supply Options
Freeway Lite may be operated from three (3) different sources:
1.The wall outlet, using the Freeway Lite AC/DC power pack.
2.Freeway Lite battery pack.
3.A 12 volt DC source (such as a car or boat).
Whichever source of power is selected, the Freeway Lite is switched ON at the ON/OFF switch (position I is ON and position O is OFF). Air is drawn into the Freeway Lite through the air filter. Compressed air will come out of the air outlet into the coiled Duratube at the air outlet. The Freeway Lite can be switched OFF using the ON/OFF switch and the supply of compressed air will stop.
CAUTION
DO NOT use the Freeway Lite for more than 20 minutes continuously in any one (1) hour. Allow a minimum of 40 minutes rest/cooling time.
Operation From The Wall Outlet
NOTE: Ensure that the ON/OFF switch is in the OFF (O) position.
1.To operate from the wall outlet, connect the Freeway Lite AC/DC power pack to the wall outlet.
10