Invacare Lap Tray instruction sheet Safety Summary, Introduction, Installation Figure

LAP TRAY

Assembly, Installation, and Operating Instructions

NOTE: Check all parts for shipping damages before us- ing. In case of damage, do NOT use the equipment. Con- tact the Carrier/ Dealer for further instructions.

SAFETY SUMMARY

WARNING

DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand these instructions, contact a healthcare professional, dealer or technical personnel if applicable before attempting to install this equipment - otherwise, injury or damage may occur.

INTRODUCTION

The Lap Trays are fully molded and designed to fit most wheelchairs. They feature a continuous lip along three (3) sides to prevent items from sliding off and is designed without comers or crevices which helps prevent the col- lection of food and dirt.

The Lap Trays are available in two (2) styles - Clear and Black. The clear trays are composed of a Thermal Poly- ester composition that allows surface scratches to be removed with a heat gun or hair dryer. The Black trays are made of ABS Plastic. Both styles are extremely durable.

The trays are available with or without a torso cutout.

The tray mounts firmly to the wheelchair by sliding onto the arm rests. The tray will mount on flat padded (SR - mounting hardware) or tubular (TR - mounting hard ware) arm rests.

NOTE: These mounting holes/ screws must be posi- tioned at the rear of the lap tray.

Standard Rail

Desk Arm Pad

(Shown)

Pin Position

NOTE: These
mounting holes/
screws must be
positioned at the
front of the lap	Full Length Arm
tray.
	Pad Pin Position

INSTALLATION (FIGURE 1)

1.Remove Lap Tray/tray rails from packaged container.

2.Measure the distance (outside to outside) at the front and rear of armrest pads.

3.Subtract this measurement from the width of the Lap Tray. Refer to the example.

Example:

Width of Lap Tray	24-inches
Armrest Measurement	- 20-inches (minus)
	- 4-inches

4.Take the difference between the two (2) measure- ments and divide by 2.

Example:	4-inches = 2
	2

5.Measure the distance from the outside edge of the Lap Tray toward the inside of the tray rail using the distance measurement obtained in STEP 4. Perform this procedure for both sides of the Lap Tray.

6.Position tray rails with the mounting holes that are closesttotheoutsideofthetrayrailsattherearofthe tray.

7.Loosely secure the tray rails to the Lap Tray with the screws provided.

Difference between the width of the lap tray and the outside of the armrests divided by two.

REAR

Sling T-nuts

Mounting Screws

Sling T-nuts

Tray Rails

FRONT

Install Tray

FIGURE 1 - INSTALLATION

1