NECK SUPPORT
Assembly, Installation, and Operating Instructions
SAFETY SUMMARY
WARNING
DO NOT install this equipment without first read- ing and understanding this instruction sheet. If you are unable to understand the se instructions, con- tact a healthcare professional, dealer, technical personnel if applicable before attempting to in- stall this equipment - otherwise, injury or damage may occur.
ATTACHING THE NECK SUPPORT (FIGURES 1 AND 2)
Center Panel (STEP 3)
Mounting
Curved BackScrews
(STEP 4)
Neck Support Bracket
Neck Support Assembly (STEP 8)
Curved Back
1.Remove neck support bracket from packaging.
2.Unzip back cover on both sides of center panel.
3.Lift center panel.
NOTE: If a NEW neck support is used on an EXISTING Curved Back than the adapter plate and support bracket MUST be used.
NOTE: If a NEW neck support is used on a NEW Curved Back than the support bracket can be used WITHOUT the adapter plate.
4.Perform Steps 4a. and 4b. or 4c.:
a.Secure neck adapter plate to the back shell with the four (4) mounting screws provided (If applicable).
b.Then secure the neck support bracket to the neck adapter plate using the two (2) mounting screws provided.
c.Secure the vertical neck post to the back shell using the two (2) mounting screws provided.
5.Close center panel with the vertical neck post ex- posed through the slot provided in upholstery.
6.Zip the back cover closed.
7.Insert horizontal post into vertical post and secure with thumbscrew knob.
8.Insert vertical post into neck support bracket.
9.Secure with a thumbscrew knob or adjustable lever.
10.Insert detent pin into through both walls of vertical post (Transport Ready Option [TRRO]).
11.If adjustment is required, refer to ADJUSTING THE NECK SUPPORT in this instruction sheet.
Thumbscrew
Knob (STEP 7)
Horizontal
Post (STEP 7)
Curved Back
Vertical Post
(STEP 7)
Thumbscrew
Knob (STEP 9)
Neck Support Bracket (STEP 8)
NOTE: Ensure that the retaining screw is located in the end of the horizontal post.
Thumbscrew Knob
Depth
Adjustment
Retaining
Screw
Height
Horizontal PostAdjustment
Stop
Vertical Post | Height |
| |
Neck Support | Adjustment |
Bracket |
|
Detent Pin | Adjustment Lever |
NOTE: Neck Adapter Plate NOT shown.
FIGURE 1 - ATTACHING THE NECK SUPPORT
ON THE CURVED BAC K
1
