Pull UP to é, Remove, Frame Battery Pack

WARNING

Lifting column MUST be in lowest position BEFORE installing frame to prevent tipping.

The frame should be placed into an EMPTY bathtub.

2.Remove the battery pack by grasping the handgrip on battery pack and pull upwards (FIGURE 17).

PULL UP TO é

Front of the Bathtub

Back of

(fixture end)

the

Bathtub

Reinstall Seat onto Bath Lift Frame (FIGURES 16-18)

NOTE: If necessary, reinstall the battery pack on the frame.

1.Raise the bath lift all the way up by pressing the UP (é) button on the pendant (FIGURE 16).

NOTE: The lift will automatically stop at the top and bottom limits if UP/DOWN buttons are not released.

Pendant

3.Lower the seat onto the frame, ensuring that the slide block on the back of the chair slides down the two (2) grooves on the frame (FIGURE 18).

NOTE: The seat MUST be lowered onto the frame until the spring loaded chair release button locks in place and an audible "click" is heard.

4.Position the Bath Lift in the bath tub, refer to POSI- TIONING THE BATH LIFT FRAME IN BATH TUB in this Instruction Sheet