Invacare Complete Guide to Compass Wheelchairs

Invacare® Compass™ XE Ultralightweight Custom Manual Wheelchair

Invacare® Compass™ XE Ultralightweight Custom

Compass™ XE Specifications

Seat width	12" - 20"
Seat depth	12" - 20"
Overall chair width open	Seat width plus 8.5"
Overall chair depth	25" - 35" (without anti-tips and
	front riggings)
Overall chair height range	28" - 38"
Back angle adjustment	80˚ to 110˚ in 5˚ increments
Tubing outside diameter	1"
Weight of chair	19 lb.*/36 lb. **
Weight capacity	250 lb.
Limited warranty	Lifetime on frames and crossbraces

*18" x 16", AT902, no rear wheels, no footrests, no anti-tippers, no wheel locks, no arms.

**18" x 16", AT902, 24SP, PNEU, 70NTAPER, seat upholstery, back upholstery, wheel locks, no arms.

Front and rear seat-to-floor-heights ( All dimensions are approx.)

	3" caster	5" caster	6" caster	6" caster	8" caster
		SALUM	AT902		1228
Fork	AT900	AT901	65KYWAY	1259	AT901
A1103	15.25"	16.25"	N/A	N/A	N/A
3" fork	15.75"	16.75"
	16.50"	17.50"
	17.00"	18.00"
A1105	16.25"	16.75"	17.25"	N/A	N/A
5" fork	16.75"	17.25"	17.75"
	17.25"	17.75"	18.25"
	17.50"	18.00"	18.50"
	18.00"	18.25"	18.75"
	18.50"	18.50"	19.00"
		19.00"	19.50"
		19.50"`	20.00"
A1108	N/A	N/A	N/A	18.00"	19.00"
8" fork				18.50"	19.50"
				19.00"	20.00"
				19.25"	20.25"
				19.50"	20.50"
				19.75"	20.75"
				20.25"	21.25"
				20.75"	21.75"

Cane Options

Sportster	10" - 14" or 12" - 16" adjustable
10˚ with push handles	14" - 18" adjustable N/A fixed
Straight with push handles	12" - 16" or 14" - 18" adjustable
	18" or 20" fixed

Knee-to-heel*

Folding frames w/ seat rails	min	max
60˚	15.25"	19"
60˚ MFX	11.50"	15.50"
70˚	14"	19"
70˚ MFX	8.25"	14"
70˚ Tapered	16.25"	20.25"
Elevating	15.75"	21.75"
90˚	5.75"	10.25"

*Range adjusts in 1" increments. Measurement taken from top of seat rail to back of footrest

Arm heights

AT99N*		5" - 10"
AT55D*		5" - 13"
AT55F*		5" - 13"
DESKADJCV, FULLADJCV*		10" - 14"
TAD**	Low Range	6" - 10"
TAF*	High Range	8" - 14"

*Range adjusts in 1" increments.

**Range adjusts in 0.5" increments.

All measurements from top of seat rail to top of armrest. On AT55D and AT55F, add 1" for upholstered arm pads. For less-seat-rail chairs, add 1.5" to above measurements (top of upper frame rail to top of armrest).

Invacare Corporation

www.invacare.com

USA

One Invacare Way Elyria, Ohio

44035-4190

(800) 333-6900

Canada

570 Matheson Blvd. E. Unit 8 Mississauga, Ontario L4Z 4G4 Canada (800) 668-5324

© 2008

Invacare Corporation. All rights reserved. Trademarks are identified by the symbols ™ and ®. All trademarks are owned by or licensed to Invacare Corporation unless otherwise noted. Stealth is a registered trademark of Stealth Products, Inc. Specifications are subject to change without notification.

Form No. 04-153

Rev. 04/08

Manual Wheelchair

12

ANSI/RESNA W/C 19 sec 6.2 Presale Literature Notification - Compass XE

A.Minimum turning radius 22.0". Minimum turn-around width 38.5".

(16" W Medium Frame chair without footrests).

B.Compass XE wheelchairs 17"D or deeper or longer than 1220 mm, exceeding the ADA definition of a common wheelchair and the maximum length requirements of lifts on public vehicles, and may therefore present particular difficulties accessing some vehicles.

C.Total wheelchair mass = 40.0 lb (18.1 kg) - including front riggings, wheel locks, TRO brackets, wheelchair-anchored pelvic belt. Does not include seating.

D.Average lateral dummy displacement = approximately 0.75" (19 mm).

E.Overall Score = 15. Overall Rating = B.

F.i. The Compass XE tested was sized to accommodate a 170 lb. test dummy. (Medium Frame, 16"W X 16"D, 60 degree front rigging, 24" composite wheels, 24" urethane tires, Invacare® Infinity® seat cushion, Invacare Personal Back™10 seat system, 6" composite/urethane casters.)

ii.The Compass XE tested was tied-down using four tie-down brackets - 2 brackets located near the front of the seat frame and 2 brackets located on the rear of base frame.

iii.The Compass XE was tested with a 170 lb. test dummy.

iv.The Compass XE tested used a wheelchair-anchored pelvic belt and vehicle-anchored shoulder belt.

v.The Compass XE tested complies with the performance requirements of ANSI/RESNA W/C 19 sec 5.3.

G.For all types of vehicles, the Compass XE requires four SAE J2249-compliant tie-down strap assemblies for effective securement.

H.When the TRRO or TRBKTS option is selected, the Compass XE provides a location for anchoring of an Invacare provided pelvic belt. This belt has been tested in accordance with ANSI/RESNA W/C 19.

I.The wheelchair-anchored pelvic belt is supplied by Invacare.