Socket Head Screws | Allen Key | ||
DETAIL “A” |
| DETAIL “B” | |
|
| ||
|
| Actuator and Boom | |
Bearing Block |
| Mast | |
|
| ||
Mast |
|
| |
|
| Kneepad | |
|
|
| |
DETAIL “C” | Boom Bearing | ||
Retainer | |||
| |||
| Mast | ||
FIGURE 2 Removing the Boom Bearing Retainer
Attaching the Walking Tutor to the Lift
NOTE: For this procedure, refer to FIGURE 3 on page 4.
1.Install the pivot assembly to the mast.
2.Replace the boom bearing retainer.
3.Swing the boom back and push the bearing block into the top of the mast.
4.Secure the bearing block to the top of the mast with the existing socket head screws.
5.Ensure that the walking tutor armrests are positioned the correct way before assembling (not shown).
6.Position the walking tutor in behind the actuator.
7.Rotate the walking tutor to match the boom orientation.
8.Using the socket head screws and locknuts, secure the walking tutor bearing block to the pivot assembly (Detail “C” and Detail “D”).
Part No 1141439 | 3 | Walking Tutor |
