CLEANING & MAINTENANCE
DEEP CLEANING
Noisy functioning (audible loud buzzing sound) is a sign that your Ionic Pro Turbo® ionic air purifier is overdue for a complete
To Deep Clean:
1.Before beginning, make sure you have read all of the safety precautions and cleaning instructions located in the “SAFETY INSTRUCTION”, “IMPORTANT WARNINGS”, and “CLEANING & MAINTENANCE” sections of this owner’s manual.
2.First, turn OFF and unplug your Ionic Pro Turbo® ionic air purifier.
3.Let it rest for a minute before sliding out the collection blades as described in the “To Clean the Collection Blades” section of this manual.
4.Use a cloth and warm, sudsy water to wipe away dirt particles on the blades’ surfaces and edges.
5.Rinse and let the blades dry thoroughly for 24 hours before
If desired, you can purchase a second set of collection blades to use while the original blades are drying to allow for virtually uninterrupted air purification. (See the “ORDERING EXTRA COLLECTION BLADES” section of this owner’s manual for details.)
Cleaning External Surfaces
Over time, some particles and dust may accumulate on the external surfaces of your Ionic Pro Turbo® ionic air purifier.
If this happens:
1.Turn off and unplug the unit.
2.Mix one ounce of soap or detergent with five ounces of water and apply sparingly with a moist sponge to wipe the outer case surfaces.
3.Do not allow any water to slip into the internal parts of the Ionic Pro® Turbo ionic air purifier as this could damage its functioning and may result in injury to you.
4.Allow the unit to dry for at least 24 hours before resuming use.
TROUBLE SHOOTING
TROUBLE | REASON |
|
|
|
|
Indication/Setting light | Machine is unplugged. | Check if plug is loose. |
does not turn on. | ON/OFF button has not | Press the ON/OFF button. |
| ||
| been pressed. |
|
| Main door not closed. | Close door. |
|
|
|
Red CLEAN light is on or | Too much dust has accumulated. | Turn off, unplug & lift the lever |
the unit shuts down. |
| to the wire cleaning mechanism |
|
| to clean the ionizing wires. |
| AC input unstable or overloaded. | Turn off, allow unit to rest |
|
| a while to return to normal. |
| Moisture on collection blades. | Temperature & moisture level |
|
| and then turn on again. |
|
|
|
Excessive noise | Collection blades are not | Remove & replace collection |
generated. | installed properly. | blades & press “On” button. |
| Too much dust has accumulated. | Clean and dry blades and |
|
| ionizing wires thoroughly.* |
| Internal parts are wet. | Keep the machine dry. |
|
|
|
*See “CLEANING & MAINTENANCE” section.
10 | 11 |