iRobot 500 Series Maintenance, Remove and empty Roomba’s bin, Clean Roomba’s filter compartment

Maintenance

To keep Roomba running at peak performance, it is recommended that you perform the following maintenance regularly:

1Remove and empty Roomba’s bin

Press button and pull to remove bin

2Clean Roomba’s filter compartment

A. Clean or replace filter*

Empty bin

B. Clean filter compartment

*Replace filter every 2 months

3Clean Roomba’s brushes

A.Remove brush guard by pulling both yellow tabs

B. Remove brush caps and use scissors

to cut any hair wrapped around the brush. Use the Roomba cleaning tool to comb hair from brush.

Brush caps

C. Remove and clean hair and dirt from Roomba’s brush bearings.

Brushes Brush bearings

Brush

caps

Visit www.irobot.com for information on keeping Roomba running at peak performance.

Tip: Bin emptying and brush cleaning should be done after every 3-5 cleaning cycles depending on the amount of hair, dirt, and debris in your environment.

Tip: If you notice Roomba picking up less debris from your floor, empty the bin and clean the brushes.

Excessive build up of hair in Roomba’s brushes and bearings can permanently damage Roomba. Inspect brush bearings regularly.

Do not attempt to run Roomba without the bearings. If you misplace Roomba’s brush bearings, contact iRobot Customer Care for replacement bearings.

20iRobot Roomba 500 Series