Operating Your Pool Cleaner - Set Up
1.Place the power supply (transformer) at least 3.6 meters / 11.8 feet from the pool and atleast 12 cm / 4 Inch above the surface.
The transformer will supply low voltage to the cleaner.
2.Uncoil the cable.
1 |
12 cm |
(4.7 inch) |
1a |
2 |
3. Place the unit in the water. | 3 | |
Turn the unit side to side | ||
| ||
in the water to allow air to |
| |
escape from the body |
| |
and then let the cleaner |
| |
sink to the bottom of the |
| |
pool. Then, spread the cable |
| |
over thesurface of the pool |
| |
asevenly as possible. |
|
4.Plug the cable into the power supply. Make sure the key on the plug corresponds exactly with the key slot on the socket of the power supply.
(See details on the next page)
5.Plug the power supply into a grounded outlet. Ensure that the electric outlet has been properly grounded.
6.Press the CLEAN button and the light will glow indicating that the system is “ ON ” and the pool cleaner will start the cleaning cycle.
4
IMPORTANT:
Please be sure to always keep your pool cleaner properly stored anywhere between 10 to 40 degrees Celsius (50 to 104 degrees Fahrenheit). This will keep the motors, plastics and seals protected.
Robot can be used in water with temperatures ranging from 13°C to 35°C (55°F to 95°F). However, the recommended optimal temperature is between 22°C and 32°C (72°F and 90°F)
