Selecting between AUX1 / AUX2
For radios that have a “SAT” button
Press the “FM” button and then the “SAT” button. Immediately press the “SEEK >>” button to scroll through the available sources. Once “AUX2” is displayed, press the “<<TUNE” button to select it.
For radios equipped with a “RADIO” or “AM/FM/SAT” button Press the “Radio” or “AM/FM/SAT” button a few times until “SAT” is displayed. Immediately press the “SEEK▲” button to scroll through the available sources. Once “AUX2” is displayed, press the “TUNE ▼” button to select it.
Toyota/Scion/Lexus PGHTY1 Operation
Selecting AUX
Press the “AM/SAT” button to switch to AM then again to switch back to SAT. Immediately turn the rotary knob to scroll through available sources. Once “AUX1” is displayed, press PRESET 3 to select it.
Selecting between AUX1 / AUX2
If you are currently in “AUX1” or “AUX2” mode turn the rotary knob to cycle through the available sources. Once “AUX1” or “AUX2” is displayed on the screen press PRESET 3 to select it.
Volkswagen PGHVW2 Operation
Selecting AUX
Press the “CD” button twice to switch the radio to the CD Changer source. This will access “AUX1”.
Selecting between AUX1 / AUX2
To select “AUX2” press preset #2. To select “AUX1” press preset #1.
Troubleshooting
Symptom | Cause | Remedy |
Radio shows | PXAUX device is | This only occurs the first time the |
“DEV INIT” | initializing. | PXAUX is powered on. Wait a few |
|
| minutes, cycle ignition off and on then |
|
| enter SAT mode. |
Radio does | Dipswitches are | See connection diagram for proper |
not recognize | not set properly | dipswitch setting. If the dipswitches |
module. | or the unit did not | are set properly disconnect the 24 pin |
| initialize properly. | |
|
| 5 minutes to reset the interface. |
No sound. | Auxiliary cable | Verify that the auxiliary cable is |
| is not connected | connected to the PXAUX and the |
| to accessory or | accessory. |
| PXAUX. |
|
7
