|
| R | |
| E |
| |
T | H |
| E |
|
| ||
|
|
| |
R |
|
|
|
T Connect the projector | |||
A |
|
| |
| S |
| to your laptop |
|
|
| |
1 Locate the required cables:
Power cord | Computer cable |
2 Connect the computer cable to the Computer 1 port on the projector.
3 Connect the other end to your laptop’s | |
or | monitor port. |
4 Plug in the power cord.
Follow these instructions to connect the projector to your laptop. For other setup options, see your User’s Guide.
Turn on your equipment
1 Turn on your laptop.
2 Remove the projector’s lens cover.
3 Make sure the 
power light is orange and not flashing.
Make sure power light is not flashing
Power button 
4 Press the 
Power button to turn on the projector.
CAUTION: Before unplugging the projector...
To shut down the projector properly
1. Press the 
Power button twice. Let the projector cool while the power light flashes orange (about 45 seconds).
2. Once the light stops flashing and stays on, it’s safe to unplug the projector.
Never unplug the projector when the 
power light is green or flashing orange.
Adjust the image
1 If you’ve turned on your laptop and you don’t see an image, press the Computer/DVI button on the projector to select Computer 1 as the image source.
NOTE: If you still see a blank screen or have other difficulties, see the troubleshooting tips on the back of this sheet.
2 Adjust the sharpness, size, and height of the image:
Focus |
| Zoom | Lens Shift |
to sharpen | to enlarge | to adjust the | |
the image | the image | image height | |
3 If your image looks like | or | , you’ve placed the projector off to | |
one side of the screen at an angle. Place it directly in front of the | |||
center of the screen, facing the screen squarely. | |||
4 If your image looks like | or | , use the Keystone button to | |
square up the image. |
|
|
|
