L
R
3
3.How to position the ear hook on the ear hook ring for left or right ear use.
The ear hook wearing style has two parts: an ear hook and an ear hook ring. One end of the ear hook forms a pin that presses into a loop on the ear hook ring and holds it there.
You will wear the headset with the ear hook behind your ear and the ear hook opening pointing down towards your jaw. Decide on which ear you would like to wear the headset and assemble the ear hook and ear hook ring appropriately.
To change from one ear to the other, pull the ear hook up and away from the loop, and press into the other side of the loop. Then remove the headset from the ear hook ring. Rotate it and replace it again with the cable posi- tioned at the ‘L’ or ‘R’ for the selected wearing side as described in point 2.
2 cm 3/4"
4 | 5 | 6 |
4.How to wear the ear hook.
To wear the headset, slip the ear hook behind your ear while keeping the ear gel centred into the middle part of your ear. The ear hook comes in two sizes for optimal fit. Please try both for best personal support and fit.
5.How to position the microphone.
Adjust the microphone by rotating it around the headset and flexing the boom arm until it is positioned less than 2 cm from the front of your mouth.
6.How to rotate the boom arm. The boom is free to rotate 360o.
Wearing the Headset with the Neckband
A neckband wearing style is included with some Jabra BIZ 2400 models. Neckbands can be purchased as an accessory for any mono Jabra BIZ 2400. To use it:
1
1.How to press the headset into the neckband ring.
The neckband can be assembled for wearing on either the left or right ear. Decide whether you would like to wear your headset on your left or right ear and position the neckband ring appropriately. Hold the neckband ring in one hand and the headset in the other. Align the headset against the outside of the neckband ring with the headset cable pointing down. Gently press the headset into the neckband ring until it clicks into place.
23
2.How to attach the ear cushion.
Align the ear cushion against the neckband ear plate so that the groove in the ear cushion slips around the ridge of the ear plate. Rotating the cushion will ensure it snaps securely into place (you can remove it as you attach it).
3.How to position the neckband on the neckband ring.
Attach the neckband by sliding the left or right tip of the neckband through the loop in the neckband ring. Note the small bump inside the neckband ring; this must align with the groove on the tip of the neckband.
6 | 7 |
