Charge your headset, Turning your headset on and off, How to…

ES PT DE IT NL SU NO SE DK GR

1. Charge your headset

Make sure that your Jabra BT5010 headset is fully charged for two hours before you start using it. Use the AC adapter to charge from a power socket, or charge directly from your PC with the USB cable provided. Use only the chargers provided in the box – do not use chargers from any other devices as this might damage your Jabra BT5010.

Connect your headset as shown in fig 2. When the LED indicator light is solid red, your headset is charging. When the LED indicator light is green, it is fully charged.

2.Turning your headset on and off

•Press the on/off/pairing button to turn on your headset(see fig 1). The LED will show the battery status to indicate the Jabra BT5010 is on (see section 7).

•Press the on/off/pairing button to turn off your headset until you see a burst of flashes.

3.Pair it with your phone

Before you use your Jabra BT5010, you need to pair it with your mobile phone.

1.Put the headset in pairing mode

•Make sure the headset is off.

•Press the on/off/pairing button marked until the LED indicator light is solid blue.

2.Set your Bluetooth phone to ‘discover’ the Jabra BT5010

Follow your phone’s instruction guide. This usually involves going to a ‘setup,’‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’ or ‘add’ a Bluetooth device.* (See example from a typical mobile phone in fig 3).

3.Your phone will find the Jabra BT5010

Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’ or ‘OK’ on the phone and confirm with thepasskey or PIN = 0000 (4 zeros). Your phone will confirm when pairing is complete. In case of unsuccessful pairing, repeat steps 1 to 3.

4. Wear it how you like it

The Jabra BT5010 is ready to wear on your right ear. If you prefer the left, pull out the earhook and rotate and insert as shown. (See fig 4).

For optimal performance, wear the Jabra BT5010 and your mobile phone on the same side of your body or within line of sight. In general, you will get better performance when there are no obstructions between your headset and your mobile phone. (See fig 5)

5. The sliding boom arm

The sliding boom arm is used for answering and ending calls, but will also give an increased audio quality when extended.

To answer an incoming call just extend the boom arm to an open position and to end the call slide the boom arm back to a closed position.

The Jabra BT5010 can of course be used with the boom arm in both positions, but will provide the best audio quality when in the open position.

6. How to…

Answer a call

•Tap the answer/end button on your headset to answer a call or

•Open the sliding boom arm to answer the call

End a call

•Tap the answer/end button to end an active call or

•Close the sliding boom arm to end an active call

Make a call

•When you make a call from your mobile phone, the call will (subject to phone settings) automatically transfer to your headset. If your phone does not allow this feature, tap on the Jabra BT5010’s answer/end button to transfer the call to the headset.

Reject a call*

•Press the answer/end button when the phone rings to reject an incoming call. Depending on your phone settings, the person who called you will either be forwarded to your voice mail or hear a busy signal.