SP-CEIL-012
1. Install the two (2) conical spacers and two (2) flat washers two, (2) hinge pin screws loosely on both sides of the base box.
2. Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box.
3. Install the two (2) angle locking screws adjust the angle, lock it, and then tighten the hinge pin screws.
Figure 7
1.Check all the hardware for proper tightness and security. Do not over tighten hardware.
1.Install the two (2) conical spacers and two (2) flat washers, two (2) hinge pin screws loosely on both sides of the base box.
2.Raise the projector with the mounting bracket
attached and slip though the hinge pin slots openings on the bracket into the base box.
3. Install the two (2) angle locking screws adjust the angle, lock it, and then tighten the hinge pin screws.
Figure 8
Page - 10 - | Installation Manual |
